Job Summary
This position will perform operating duties and contribute to the department as directed by supervisor.
Job Responsibilities
- Plan and perform all required duties to set up any capacity punch, mechanical or hydraulic press to perform a wide range of complicated, and at times, unusual blanking, drawing, embossing, bending, punching, piercing and similar press operations on a wide variety of sheet metal parts of various metals (setups may be difficult involving the use of progressive, compound, complex forming and deep drawing dies
- Check setup to insure tightness of all clamps and bolts
- Inspect first piece and make any required operational adjustments
- Instruct operator in proper procedures and methods, safety procedures and other matters affecting his work
- Determine cause of faulty operation and take necessary steps to correct; perform a variety of similar or associated duties as required or directed
- As necessitated by workloads or other conditions, or as directed, operate any press on special or production work
- Detect and report all defective materials, improper operation, and unusual conditions to proper supervision
- Maintain work area and equipment in a clean and orderly condition
- Follow prescribed or standard safety regulations
- Other duties as assigned
Qualifications
- High School diploma or equivalent
Equal Opportunity Employer/Protected Veterans/Individuals with Disabilities
This employer is required to notify all applicants of their rights pursuant to federal employment laws. For further information, please review the Know Your Rights (https://www.eeoc.gov/poster) notice from the Department of Labor.
