Description:
- This position will work within teams to weld aluminum and steel enclosed and aluminum open trailer frames
-
Following health and safety rules, wear personal protective equipment
-
Read and correctly interpret work orders
-
Proper operation of welding machines, grinders, torches, tape measures, squares, cranes and miter/chop saws
-
Proficiency at reading and executing BOM's and blueprints
-
Demonstrate understanding and application of weld types (ex: Fillet, Seam, Spot, etc.)
-
Demonstrate understanding and application of joint types (ex: Butt, Corner, Edge, Lap, Tee)
-
Demonstrate understanding and application of weld pass positions (Push/Pull, Uphill/Downhill, etc)
-
MIG Weld aluminum
-
MIG Weld steel
-
TIG Weld aluminum
-
Demonstrate understanding and proper use of framing jigs for models and layouts
-
Demonstrate ability to perform within multiple workstations (Frame Table, Walls, Roof, Fab)
-
Ensure correct axle placement and squareness
-
Measure, square, and plumb linears prior to final weld placements
-
Ensure ramp doors/gates are installed plumb and square and function properly
-
Grind any raised welds in areas that will be covered by another flush mount material later (Skins, Roofing, Wood)
-
Inspect work for completion prior to releasing to next cell
-
Store tools and materials in proper locations when not in use
Maintain clean shop floor between units and at the end of shift
Requirements:
- Use various power and hand tools, experience preferred
-
Read and use a tape measure
-
Willingness to cross-train between departments
-
Read and follow work instructions
-
Able to work 40 - 50 hours a week
-
Good attendance is required
Physical Requirements:
-
Prolonged periods standing, reaching, bending, kneeling, and twisting
-
Must be able to move up to 75 pounds at times
PI766e163b9a5e-25404-40321570
