The CNC Router Operator is responsible for safely operating the Onsrud CNC router to cut production materials to specification, support downstream departments, and maintain quality, efficiency, and a clean and organized work area.
-
Operate the Onsrud CNC router to cut production materials per work orders, cut lists, and shop priorities.
-
Verify correct material type, thickness, and orientation before cutting (foam, fiberglass, Aqua Steel, or other approved materials).
-
Load programs, confirm revision levels, and follow standard setup procedures (tooling, vacuum/fixturing, offsets as required).
-
Perform first-piece and in-process quality checks (dimensions, edge quality, surface condition) and document results as required.
-
Label, stage, and deliver cut parts/kits to the correct department/location; coordinate priorities with Lamination and Production.
-
Monitor machine performance during runs and respond to alarms/issues; perform basic troubleshooting within scope and escalate when needed.
-
Perform preventive maintenance and daily care: clean machine/table, verify vacuum performance, check tooling condition, maintain dust collection, and complete checklists as assigned.
-
Maintain accurate production records (work orders, scrap tracking, rework notes, downtime reasons if required).
-
Follow all company safety rules and procedures, including PPE requirements, fiberglass handling rules, and LOTO expectations.
-
Maintain 5S standards and participate in continuous improvement (scrap reduction, cycle-time improvement, and better material flow).
-
High school diploma or equivalent preferred (or equivalent work experience)
-
Experience operating CNC routers (Onsrud experience preferred; comparable CNC router experience acceptable).
-
Ability to safely handle materials and parts; comfortable working around fiberglass, dust collection, and adhesives/resins as applicable.
-
Ability to read work orders, cut lists, and basic measurements (tape measure; calipers/gauges as required).
-
Basic mechanical aptitude and ability to perform routine maintenance/checklists.
-
Forklift certified (or ability to become certified).
-
Strong communication and teamwork skills; ability to coordinate priorities with production departments.
-
Ability to adapt to production changes and maintain a steady, safe pace.
-
Basic program troubleshooting knowledge (tool paths, feeds/speeds concepts, tool wear recognition).
-
Experience with vacuum tables, fixturing, tool changes, and scrap tracking.
-
MS Office or basic computer skills for logs, checklists, and documentation.
-
Manufacturing environment with noise, dust, and fiberglass materials.
-
Standing/walking for extended periods; bending, reaching, and lifting as needed.
-
Must be able to lift up to 50 lbs (adjust as required by facility standard).
-
Must be able to work overtime and Saturdays as needed.
