Check for count accuracy and conformance to specification
Double check for quality issues, communicating them to control room operator or wet end operator
Measure finished sheet for accuracy
Insert Proper load tags into finished “measured” units
Check unit for appearance
Operate count station and load tag printer
Restack non-conforming units
Hand-flip bundles when warped, or otherwise required]
Properly document non-conforming materials onto disposition sheet
Determine whether order is complete or partial
Operator must wear all required personal protective equipment
Operator must be proficient in using/reading tape measure and safe use of utility knife
Operator must keep work areas clean and free of debris, including keeping floor clean of sheets
Operator must be able to safely lift/move up to 50lbs during regular work shift
Operator must follow lock-out/ tag-out procedures
Prepare and set in place the “Top” dunnage for unit strapping
Counting and stacking finished product
Reading orders
